Installing Faucet - No Brainer?
My husband, a not-so-handy architect, thinks we need to have our not-so-competent handyman install our new kitchen faucet. Isn’t it pretty simple? Can’t anybody (like me) do it?
My husband, a not-so-handy architect, thinks we need to have our not-so-competent handyman install our new kitchen faucet. Isn’t it pretty simple? Can’t anybody (like me) do it?
It’s easier than you think. Harder on your back than anything else, and be sure to read through the instructions AND check to see what you’ve got under the sink, have all the tools you might need before you turn off the water and have a half disassembled faucet and have to go to the store (at 11pm, usually) . And I (a woman) have replaced faucets a few times, along with a lot of other plumbing projects. If you (or any other readers here) are concerned about having a bad experience at a plumbing supply store go to Michael’s Plumbing Supply on Flatbush Avenue & Clarendon. Michael is the best, he gives amazing advice and explains everything you need to do when tackling any type of project, simple to complex. I swear I have acquired apprentice-plumber equivalent knowledge and confidence as a result of frequenting (sometimes multiple times in one day) his store. You won’t get this service at Home Depot! Good Luck! You can do it!
Can I just add… Steve above (thetinkerswagon) should be your Handyman!! I don’t have any proof that he’s any good other than he seems like a class act…
He provided a sweet explanation of how to deal with the supply lines and what to watch out for. No mention of the fact that he’s a handyman himself.
“Master Plumber” is another example. These types of guys should get everyone’s business (at least to try out).
Class acts that have no problem sharing some helpful info — and then subtly saying, “Hey, but if you need anything else I’m available.” That’s nice.
I have not read all of the posts with this, but:
as one person said be sure that to bend the copper lines. I would ad, put a wrench on them and “backturn” them as you tightent the supply lines. By back turn, I don’t mean turn but put some pressure on them to balance the pressure from tightenting the supply.
Do not over tighten the speedy connects on the supply lines. These should be hand tightened plus about 3/4 turn with a wrench. Any more and you may crush the seal.
Yes, the nuts will be a pain, but not unmanagable.
Usually the worst thing with changing faucets is that the turn off valves don’t hold. When that happens, the entire floor or house must be turned off.
Steve
http://www.thetinkerswagon.com
oooh, a Dyson with diamond earrings, Minard has read my mind. Can you speak to my boyfriend?
I’m a big fan of DIY repairs and have replaced a few bathroom faucets (using my trusty basin wrench), but when I had to replace my single lever kitchen faucet several years ago I was unable to get the old one off. The plumber tried for a long time and finally cut the thing off. There’s no harm in trying, but sometimes you have to call a pro.
Another reason why full-serve buildings are expensive. In my building I call the super the night before and say: I need this done tomorrow by the time I get home from work. Boom, done.
this person was mentioned positively on the bococa mailing list.has anyone used her?
Jess works on water/waste/heating/fixtures/systems. Her number is 917.207.2403.
cmu: exactly!
same for abdominal surgery.
I have done work like this before. I would love to take a look and if possible submit a proposal to install the faucet. My name is Anthony and my email is aodrafting@gmail.com. Thanks and good luck.