Partial fireplace removal
The only thing standing between me and a dreamy 36″ stove is this non working 49″ wide fireplace. I’d like to recess the stove and hood within the column so it wouldn’t jut out like the sink in the photo. In order to avoid the cost of re linig the FP I would vent the…
The only thing standing between me and a dreamy 36″ stove is this non working 49″ wide fireplace. I’d like to recess the stove and hood within the column so it wouldn’t jut out like the sink in the photo. In order to avoid the cost of re linig the FP I would vent the hood directly through the back wall of the house.
Has anyone done this? If so,how much did it cost and can you recommend a contractor to do the work?
Thanks!
This looks exactly like the kitchen in my last apartment. So much so, that I am tempted to give the address and ask if this is the same building. I’ll resist the urge. I had about a foot of brick on the outsides and a space big enough to slide my stove back into in the center. That central part, where the old coal stove probably once was, is all the area that you have to play with. It is probably only slightly taller than the sink (or stove as the case may be).
3:09 and 6:10 are correct with regard to the structural element to the flue. Also, you don’t know what previous people have done with the flue. For example, the flue can be used to run electrical lines or other risers. You might open up the space and find you have to seal it again.
P.S.: You made me a little homesick for the old place.
We had this same situation. We removed the tile and put the stove in the fireplace but we are venting through the chimney. Big Apple Chimney did the work.
I am looking to do the same thing in my kitchen. I hope someone come up with some good resources.
I’m putting in another vote to keep the sink. A fantastic vintage farm sink is just as much a showpiece in a kitchen as a big fancy range. IMO anyway. I know most people are really into large, high-end ranges. I’m just a huge fan of leaving some vintage and original elements in kitchens for a unique, eclectic look that isn’t boringly copied right out of a kitchen designer’s showroom.
If you need to vent a range out a wall, code requirement is 10′ clearance from the vent to the nearest window.
What else does the fireplace flue vent? That might be an issue
i also like your sink. Can’t argue with an architect…
Undoubtably you have masonry above that needs to be supported. Depending on what is below you, you can install two 4″ lally columns and a header to pick up the masonry weight above.
I’ve done this, for the same reason as you (recessing a cooktop). The image was posted some time back on brownstoner’s kitchen survey.
It goes without saying that whoever does this work should know what they are doing, and particularly understand on what exactly the lallys will bear.
Oh, can I have your sink if you do make the change? I LOVE it.