Forum

« Calling all Junior 4 floorplans! moving radiator connection/recessed panel »

December 6, 2008

Where to buy plexiglass for storm door?

Where to buy plexiglass for storm door?

Does anyone know where is a good place in Brooklyn or Queens to buy a few square feet plexiglass?

The plexiglass on the bottom-half of my storm door cracked so I will need to replace it before the cold of winter sets in.

Comments

There are probably places in Brooklyn and Queens, but Canal St. in Manhattan has been plastics central for many, many years:
T & T Plastic Land Inc., 315 Church Street - (212) 925-6376
http://www.plasticland.com/
Canal Plastics Center, 345 Canal Street - (212) 925-1666
http://www.canalplasticscenter.com/index2.shtml

Posted by: vinca at December 6, 2008 10:53 PM

There is a place in Brooklyn, I forget the name. It's on 3rd Ave near Carroll Street, just before Carroll when traveling Manhattan-bound.

Posted by: denton at December 7, 2008 9:21 AM

See Orlando at Fantasy Plastic Center on 3rd Ave off of Carroll street. (718) 855-5520. Tell them AL the ladlords General Contractor sent the Rec.

http://www.fantasyplastics.com/

Hope that was helpful,
Al Rosario
ACR General Contracting, Inc.
(917) 573-3304

Posted by: alrosariojr at December 7, 2008 11:23 AM

I bough several pieces of plexiglass last month and found the most reasonable priced place on Fort Hamilton Pkwy between 39th and 40th Streets. Parking is tough there. A shop on 4th Ave near 60th Street wanted 3 times as much for the same plexiglass. Expect to pay around $20 at the Ft. Hamilton shop.

Posted by: yaakovdoe at December 7, 2008 1:46 PM

Thanks, guys for your help. I'll check these places out.

-D

Posted by: davieeng at December 7, 2008 1:59 PM


home depot carries plexi but they will not cut it.

if you need assistance, please feel free to contact me:

Steve Cymbalsky
www.thetinkerswagon.com

Posted by: thetinkerswagon at December 8, 2008 9:41 AM


home depot carries plexi but they will not cut it.

if you need assistance, please feel free to contact me:

Steve Cymbalsky
www.thetinkerswagon.com

Posted by: thetinkerswagon at December 8, 2008 9:41 AM

Post a comment

Please be patient while your comment is published. It may take a moment.