Forum
« Carpenter Recommendation Moving the electrical outlet and cable input to mount tv to the wall »
June 2, 2008
Glass cut table top?
I am looking for someone to cut a piece of glass to fit on an antique dining table (4x6). Does anyone have a recommendation for a glass cutter? I can trace the size needed myself and pick-up the glass, once cut. Also, does anyone know how much it might cost? I was quoted $460, but this seems high.
Comments
Dunno what's a reasonable cost but try Albert Stained Glass on St Marks a call. They have the equipment for it.
http://www.albertstainedglass.com/
Posted by: Steve at June 2, 2008 5:00 PM
Park Slope Glass
Posted by: guest at June 2, 2008 5:20 PM
Had it done for outdoor table about that size a few years ago by the glass place on 5th ave in north slope - maybe around bergen. Price sounds a little high, but I can't remember how much it was. Make sure it's tempered glass at least 1/2" thick which does cost more.
Posted by: guest at June 2, 2008 6:21 PM
Cristal Vetro
Posted by: guest at June 2, 2008 7:11 PM
Umm, 1/2 tempered is overkill and will cost a fortune. Call hecht & sohn (they're next to the bed stuy home depot) on willoughby (I think). 3/8 tempered should do just fine. I've purchased much glass from these guys and they've been good to me.
Posted by: guest at June 2, 2008 8:44 PM
1/8" = overkill? relax.
Posted by: guest at June 2, 2008 11:21 PM
Post a comment
Please be patient while your comment is published. It may take a moment.