Forum
« Anyone done radiant heat? Barbed Wire »
February 14, 2008
need a mason?
I need to make a 4" hole in my back brick wall to vent a gas dryer. Who do I use to do this hopefully small and quick job? Thanks.
Comments
If you're handy you could rent a core driller and do it yourself. Just wait until it's above freezing because there will be alot of water involved.
Posted by: Bklyn Fire Alarm Guy at February 14, 2008 9:11 AM
LN masons did a similar job venting a kitchen and dryer vent in my townhouse. I found them in the archives. They were affordable and best of all, in and out.
Posted by: guest at February 14, 2008 12:34 PM
Do you have any more info on LN Masons. I cannot find any references to them. Thanks.
Posted by: guest at February 14, 2008 3:23 PM
I posted the same exact question a few months back with no response. if you are able to find LN masons, could you please post the contact info here? I searched but I cant find them either.
Posted by: cornetor at February 14, 2008 3:32 PM
Call Matt at 347 417 4500.
Posted by: guest at February 15, 2008 7:20 AM
sorry had to fish out my notes. LN masons, Lou or Nick, 347-407-1816.
Posted by: guest at February 15, 2008 5:37 PM
Post a comment
Please be patient while your comment is published. It may take a moment.