Forum

« Kitchen Venting Parking near Sackett St and Henry St »

October 3, 2007

condensation

I put in double pane windows last year from Mega Glass, and i noticed that between the panes of glass there is sometimes a fog or some other type of buildup. This really occured in the winter. Is that common in thermal windows?

Comments

It may have to do with the location of your heating diffusers/radiators (depending on type of system). If you are not dealing with the heating load at the location where they occur--the windows--then you may see condensation build up. Or, you do not have a tight seal in your insulation cavity between the 2 panes of glass, which is something worth taking up with Mega Glass.

Posted by: Espresso at October 3, 2007 12:48 PM

It means the seal between the 2 panes of glass has been compromised. You should have had at least a 5 year warranty on the seal.

Posted by: cm at October 3, 2007 2:19 PM

The seal is broken. Call Mega to view problem and compensate.

Posted by: bergenbabe at October 3, 2007 3:27 PM

The seal is broken. Call Mega Glass and show them, they should replace if it is under warranty.

Posted by: bergenbabe at October 3, 2007 3:29 PM

Sounds as if there's condensation... seal's broken, call Mega, it should be replaced.

Our co-op was very displeased with Mega Glass
and stopped doing business with them...
this was about ten years ago, so maybe they have gotten things together since then.

Posted by: bren at October 3, 2007 5:13 PM

I'm amazed this forum could actually have a 5 answer smart talk.
Thank god

Posted by: guest at October 3, 2007 9:51 PM

please don't bring god into it.

Posted by: guest at October 3, 2007 10:13 PM

I've had this problem on a few of my windows.
They were called "double hung aluminum windows".
I got them fixed by a general contractor that renovated our kitchen and bathroom.
It's been almost two years, and the condensation has not come back.

I think their website was "www.ChineseContractor.com".
I forgot their phone #.

Posted by: guest at October 6, 2007 4:03 AM

Post a comment

Please be patient while your comment is published. It may take a moment.